• Recent
    • Docs
    • Github
    • 百度网盘
    • Onedrive
    • Official
    • Shop
    • Register
    • Login

    Introduction to COOL PI CM5 interface

    Scheduled Pinned Locked Moved Pi CM5
    72 Posts 7 Posters 6.0k Views
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • G
      george
      last edited by george

      Top-level interface

      1.png

      • The 2X20 pin interface is compatible with CP4 and integrates multiple UART, I2C, SPI, CAN and other functions.

      • Three function keys are PWR, RST and LOADER.

      • 2X2 PIN POE connector,such as CP4.

      • 30pin fpc vertical connector can directly drive standard 30PIN EDP interface LCD. Resolution up to 3840 * 2160

      • The MICRO HDMI-RX interface can support up to 4KP60 video signal input.

      • TF card with self-locking.

      • Two native USB3.0 interfaces, one of which supports OTG function.

      • Two Gigabit Ethernet interfaces, one of which supports POE function.

      • Two HDMI2.1 interfaces with a maximum resolution of 8K.

      • Stereo headphone stand with MIC input function.

      • Two native USB2.0 interfaces.

      • One TYPEC power supply interface, consistent with CP4.

      • The external power interface of 2PIN can support DC power input.

      • 1 standard PCIE 4X connector, currently only supports PCIE3.0 2X/1X mode.

      • SSD interface, only PCIE-M2-2242 size hard disk is supported.

      • Standard 7PIN SATA3.0 interface, 4PIN power interface.

      • M.2 WIFI module interface, supporting multiple general WIFI modules.

      • Dual MIPI LCD interfaces support simultaneous output of two MIPI interface LCDs. The resolution of a single LCD is up to 1920 * 1200. It supports the MIPI DSC function.

      • Four independent MIPI camera interfaces support four camera inputs at the same time. It can be configured as 2X4LINE or 4X2LINE mode.

      Bot-level interface

      2.png

      • One 30PIN EDP interface can directly drive LCD output.

      • MXM 314PIN core board connector.

      Welcome to put forward good suggestions. We can consider revising them.
      顾 L 3 Replies Last reply Reply Quote 1
      • T
        Twsuts
        last edited by

        @george 您好,请问一下底板资料啥时候出来

        G 2 Replies Last reply Reply Quote 0
        • 顾
          顾真牛 @george
          last edited by

          @george 不错不错😊

          1 Reply Last reply Reply Quote 0
          • 顾
            顾真牛 @george
            last edited by

            @george 就是俩usb3 是不是稍微少了点呀 板子上留几个usb的接线口也行呀

            顾 G 2 Replies Last reply Reply Quote 0
            • 顾
              顾真牛 @顾真牛
              last edited by

              @george 哦 还有俩usb2的 应该够用了,

              1 Reply Last reply Reply Quote 0
              • G
                george @Twsuts
                last edited by

                @Twsuts 底板已经在制版中。预计月底可以出来。

                顾 1 Reply Last reply Reply Quote 0
                • G
                  george @顾真牛
                  last edited by

                  @顾真牛 有标准PCIE接口,USB3.0不够可以扩展。外置4个USB接口,2个U2 两个U3。一般场景可以满足。

                  1 Reply Last reply Reply Quote 0
                  • G
                    george @Twsuts
                    last edited by 大法师

                    @Twsuts 正常需要初步验证和测试完成以后,底板资料才可以开放。目前核心板已经是稳定版本。

                    1 Reply Last reply Reply Quote 0
                    • 顾
                      顾真牛 @george
                      last edited by

                      @george 已经拿到板子在测试验证了吧 放些图吧

                      G 1 Reply Last reply Reply Quote 0
                      • G
                        george @顾真牛
                        last edited by

                        @顾真牛 这个还没有贴片回来,拿到后会第一时间反馈。

                        1 Reply Last reply Reply Quote 0
                        • L
                          likeshixi @george
                          last edited by

                          @george 提问关于COOL PI CM5是否支持Intel AX210NGW 网卡问题?谢谢 O1CN011RICxo1YFKR5fxzQ1_!!52923029.jpg

                          大法师大 1 Reply Last reply Reply Quote 0
                          • 大法师大
                            大法师 @likeshixi
                            last edited by 大法师

                            @likeshixi
                            支持的,需要配置内核驱动,另外补充相应的firmware文件iwlwifi-ty-59.601f3a66.0.tgz 解压到/lib/firmware

                            f9c3c772-b942-42ee-9736-cde5b43c89d2-1680262991294.png

                            github拉取内核同步编译试下,已加入该模块配置

                            jack@cool-pi.com

                            W 1 Reply Last reply Reply Quote 0
                            • W
                              wuming
                              last edited by

                              安装了AX210wifi网卡,怎么配置内核驱动,请给一个详细的教程

                              1 Reply Last reply Reply Quote 0
                              • W
                                wuming @大法师
                                last edited by

                                @大法师
                                安装了AX210wifi网卡,怎么配置内核驱动,请给一个详细的教程,而且文件iwlwifi-ty-59.601f3a66.0.tgz链接打不开

                                G 1 Reply Last reply Reply Quote 0
                                • G
                                  george @wuming
                                  last edited by

                                  @wuming 驱动默认已经集成。只需要拷贝BIN文件进去。晚点发链接出来,先帮忙上传一下dmesg

                                  G W 2 Replies Last reply Reply Quote 0
                                  • G
                                    george @george
                                    last edited by george

                                    @george WIFI固件下载链接如下 ,根据日志信息把对应firmware拷贝到机器/lib/firmware目录即可。

                                    git clone git://git.kernel.org/pub/scm/linux/kernel/git/firmware/linux-firmware.git
                                    
                                    1 Reply Last reply Reply Quote 0
                                    • W
                                      wuming @george
                                      last edited by

                                      @george :但是没有root 账户密码,连U盘都不能打开。

                                      大法师大 1 Reply Last reply Reply Quote 0
                                      • 大法师大
                                        大法师 @wuming
                                        last edited by

                                        @wuming

                                        使用coolpi密码  更改U盘挂载权限
                                        
                                        sudo chown coolpi:coolpi /media/coolpi
                                        
                                        

                                        重新拔插U盘就可以访问

                                        jack@cool-pi.com

                                        1 Reply Last reply Reply Quote 0
                                        • W
                                          wuming
                                          last edited by

                                          三个*.ucode文件已经拷贝到/lib/firmware文件夹中,重启系统还是没有反应,看不到wifi的相关信息。

                                          J 1 Reply Last reply Reply Quote 0
                                          • J
                                            jack_admin @wuming
                                            last edited by

                                            @wuming dmesg输出传一份

                                            W 1 Reply Last reply Reply Quote 0
                                            • 1
                                            • 2
                                            • 3
                                            • 4
                                            • 1 / 4
                                            • First post
                                              Last post